Square‐Wave Voltammetry of Electroinactive Surfactants

Under the influence of previously published and some new theoretical results, potential‐ dependent adsorption and desorption of model electroinactive surfactants Triton X‐100 (T‐X‐100 or polyethylene glycol p‐(1,1,3,3‐tetramethylbutyl)‐phenyl ether) and sodium dodecyl sulfate (SDS) on the static mercury drop electrode (SMDE) were studied by square‐wave voltammetry (SWV). Although (according to the theory) the resulting current – potential curve should consist of two highly separated peaks, only desorption signal could be seen on each experimentally obtained voltammogram, most probably because of the limitations concerning the available potential range. Different properties of the recorded peak are in good agreement with the theory indicating that square‐wave voltammetry could be treated as a potential tool for tensammetric studies of electroinactive surface active substances.     

预处理温度对甘油氢解双金属Ir-Re催化剂性能的影响

在生物柴油生产过程中大量副产的甘油是重要的生物质转化平台化合物.通过甘油氢解制备高附加值的1,3-丙二醇是甘油的资源化利用的重要途径,能够显著提高生物柴油产业的经济效益,同时也是探究更复杂的糖醇类化合物氢解的模型反应.因此,甘油氢解制备1,3-丙二醇成为当前学术界的研究热点.通常,以Re或W为助剂修饰的贵金属催化剂是有效的甘油选择性氢解制1,3-丙二醇的催化剂,其中,双金属Ir-Re催化剂是目前最高效的催化剂之一.甘油氢解反应是典型的结构敏感性反应,它的催化性能依赖于双金属催化剂的结构,而后者受制备工艺条件如热处理方式及条件的影响.最近,我们报道了以直接还原法(即浸渍-还原法)制备的Ir-Re催化剂为合金结构,在甘油氢解中表现出更为优越的反应活性及目前报道中最高的1,3-丙二醇生成速率,并提出了可能的双功能反应机理,即催化剂表面的Re-OH酸性位和Ir均为甘油氢解的活性位.本文采用直接还原法制备KIT-6(具有三维有序介孔孔道结构的SiO2)负载的双金属Ir-Re催化剂,进一步研究还原温度对Ir-Re/KIT-6的结构及其催化性能的影响,揭示催化剂表面酸性在甘油氢解反应中的重要作用并阐明其构-效关系.结果显示不同还原温度(400–700 oC)制备的催化剂的比表面积、孔体积及孔径数据基本一致,表明还原温度对Ir-Re/KIT-6的织构性质的影响很小.根据程序升温还原和透射电镜-能量散射点扫描结果可知,不同温度还原后的催化剂表面Ir和Re均以金属态形式存在,同时两者存在直接的相互作用,形成了Ir-Re合金;而漫反射红外图谱上CO吸附峰的红移以及峰形的显著变化也印证了Ir-Re合金结构的形成. TEM结果显示,在400–700oC还原后得到的Ir-Re合金纳米粒子均匀分布于KIT-6上,尺寸基本一致(2.5–2.8 nm),与CO化学吸附结果一致.此外, NH3-程序升温脱附结果表明催化剂的酸量随着还原温度的升高而逐渐增大,但酸强度没有明显变化,这可能是由于高温还原进一步促进了Ir和Re的相互作用,在原子尺度上混合更为均匀所致. Ir-Re催化剂上甘油氢解反应结果显示,随着还原温度由400提高到600 oC,所制催化剂的活性先增加而后趋于稳定.由此可以认为Ir-Re催化性能的差异与Ir分散度和酸强度的关联较小,主要是由于催化剂表面酸量所致.直接关联酸量与反应活性(以反应时间内的平均1,3-丙二醇生成速率表示)可以看到,反应活性随着酸量的增加而线性增大,表明Ir-Re/KIT-6的表面酸量直接影响了甘油氢解反应速率的快慢,即酸位Re-OH直接参与了催化反应.众所周知, Re金属活化H2的能力很弱,而金属Ir在反应中起到催化加氢的作用.实验结果很好地印证了Ir-Re合金催化甘油氢解反应的双功能反应机理,即酸位Re-OH与金属Ir协同参与氢解反应,分别作为甘油吸附位和H2活化中心,因此提高催化剂的表面Re-OH的数量将是进一步提高催化活性的途径之一.总的来说,在400–700 oC还原得到的Ir-Re/KIT-6催化剂具有Ir-Re合金结构.还原温度对催化剂的织构性质、金属纳米粒子的尺寸、Ir的分散度及表面酸强度的影响不大,但还原温度的升高有利于Ir和Re的相互作用,显著提高了催化剂的表面酸量,因而提高催化活性.此外,表面酸量和反应活性的线性关系表明酸位Re-OH参与Ir-Re合金催化甘油氢解反应,印证了双功能反应机理.     

Poly(N-isopropylacrylamide)-grafted dual stimuli-responsive filter paper for protein separation

Thermal and salt dual stimuli-responsive filter-paper-based membranes were prepared by UV-induced grafting of NIPAM-based polymers on paper surface. The grafting ratio could be controlled by monomer concentration during grafting polymerization. The results from pressure drop measurement of the mobile phase flowed cross the membrane demonstrate that an appropriate grafting ratio would be 8%-10%. Protein adsorption on the membrane through hydrophobic interaction could be promoted by increasing temperature and lyotropic salt concentration. The effect of grafted polymer structure on protein binding performance was studied. Filter paper grafted with NIPAM-based branched copolymer consisting of hydrophobic monomer moieties shows ten times higher protein binding capacity than that of the original filter paper. The separation of plasma proteins using the dual stimuli-responsive membrane was examined to demonstrate feasible application for hydrophobic interaction chromatographic separation of proteins.     

静电纺丝法制备PLLA/g-HNTs复合纳米纤维膜及其性能研究

以辛酸亚锡为催化剂,利用HNTs表面的羟基引发L-LA开环聚合,合成了表面接枝聚(L-乳酸)(PLLA)链段的埃洛石纳米管(g-HNTs),通过红外、热失重和透射电镜对改性前后HNTs的组成与形貌进行了观察;然后采用静电纺丝技术制备了PLLA纳米纤维膜以及不同组成的PLLA/HNTs和PLLA/g-HNTs复合纳米纤维膜,探讨了纺丝条件对纳米纤维膜形貌的影响,并对复合膜的组成、形貌、力学性能和细胞相容性进行了研究.结果表明,当HNTs与L-LA的摩尔投料比为1∶10时,g-HNTs表面PLLA链段的接枝率为14.22％,HNTs纳米管的形态在接枝后变化不大,易于在无水乙醇中分散.电压强度和进样速率对纤维膜的形貌有一定影响,当电压强度为15 kV、进样速率为1 mL/h时,电纺纤维的直径较为均匀.复合纤维膜中g-HNTs在基体PLLA中的分散性以及与基体的界面相容性要优于相应的HNTs,当g-HNTs含量高达40％时,复合纳米纤维膜中的纤维形态仍然保持较好,可以得到连续、粗细较均匀的纤维;随着HNTs和g-HNTs含量增加,复合纳米纤维膜的拉伸强度和模量先增大后下降,当HNTs和g-HNTs的含量为5％时,两种复合纳米纤维膜的拉伸强度和模量均达到最大值,但PLLA/g-HNTs组复合纳米纤维膜的拉伸强度始终大于相应的PLLA/HNTs组.体外3T3细胞培养结果显示,PLLA/g-HNTs复合纳米纤维膜具有良好的细胞相容性,且优于相应的PLLA和PLLA/HNTs纳米纤维膜.     

A Nitrite Electrochemical Sensor Based on Boron‐Doped Diamond Planar Electrochemical Microcells Modified with a Monolacunary Silicotungstate Polyoxoanion

A new boron doped diamond microcells (BDD) was modified, for rapid, selective and highly sensitive determination of nitrite, using a coating film of polyoxometalates (POMs), formed by cyclic voltammetry on the molecular p‐phenylenediamine (PPD) functionalized BDD. The scanning electron microscopy (SEM) technique was used to examine the morphology of (PPD/SiW₁₁) modified (BDD) electrode. It was found that (SiW₁₁) layer was uniformly formed on the electrode surface. It was observed that (BDD/PPD/SiW₁₁) showed excellent electrocatalytic activities towards nitrite ion. Under the selected conditions, the anodic peak maximum at ?0.6 V was linear versus nitrite concentration in the 40 µM–4 mM range, and the detection limit obtained was 20 µM. The newly developed electrode has been successfully applied to the determination of nitrite content in real river water samples.     

Imprinted ZnO nanostructure-based electrochemical sensing of calcitonin: A clinical marker for medullary thyroid carcinoma

The present work describes an exciting method for the selective and sensitive determination of calcitonin in human blood serum samples. Adopting the surface molecular imprinting technique, a calcitonin-imprinted polymer was prepared on the surface of the zinc oxide nanostructure. Firstly, a biocompatible tyrosine derivative as a monomer was grafted onto the surface of zinc oxide nanostructure followed by their polymerization on vinyl functionalized electrode surface by activator regenerated by electron transfer–atom transfer radical polymerization (ARGET–ATRP) technique. Such sensor can predict the small change in the concentration of calcitonin in the human body and it may also consider to be as cost-effective, renewable, disposable, and reliable for clinical studies having no such cross-reactivity and matrix effect from real samples. The morphologies and properties of the proposed sensor were characterized by scanning electron microscopy, cyclic voltammetry, difference pulse voltammetry and chronocoulometry. The linear working range was found to be 9.99 ng L⁻¹ to 7.919 mg L⁻¹ and the detection limit as low as 3.09 ± 0.01 ng L⁻¹ (standard deviation for three replicate measurements) (S/N = 3).     

Dynamic polarizability of two‐electron ions under Debye screening

The effect of plasma screening on the dynamic dipole polarizability (DPP) of two‐electron ions Be²⁺, B³⁺, and C⁴⁺ has been investigated using highly correlated exponential wave functions within the framework of pseudostate summation technique and Debye screening concept. Plasma‐screening effect on the oscillator strengths (OS) of the ultraviolet and visible series has also been investigated for the systems Li⁺, Be²⁺, B³⁺, C⁴⁺. The DPP are reported as functions of screening parameters. The OS for S‐P transitions are also reported for various screening parameters. The OS and dynamic polarizability show interesting behavior with increasing screening strength and nuclear charge. © 2015 Wiley Periodicals, Inc.     

Two‐dimensional reactive scattering with transmitted quantum trajectories

A simple and easy‐to‐implement method is presented for the study of time‐dependent reaction dynamics by propagating an ensemble of transmitted quantum trajectories. During the trajectory evolution, reflected trajectories are gradually removed and all the remaining trajectories represent the transmitted subensemble. The removal process of reflected trajectories avoids numerical instabilities arising from node formation in the reactant region, and allows stable long‐time propagation of transmitted trajectories. This method is applied to a two‐dimensional model chemical reaction. Excellent computational results are obtained for the time‐dependent reaction probabilities evaluated by the time integration of the probability flux. © 2014 Wiley Periodicals, Inc.     

Fabrication of solid‐state nanopores and its perspectives

Nanofluidics is becoming an extensively developing technique in the field of bioanalytical chemistry. Nanoscale hole embed in an insulating membrane is employed in a vast variety of sensing platforms and applications. Although, biological nanopores have several attractive characteristics, in this paper, we focused on the solid‐state nanopores due to their advantages as high stability, possibility of diameter control, and ease of surface functionalizing. A detection method, based on the translocation of analyzed molecules through nanochannels under applied voltage bias and resistive pulse sensing, is well established. Nevertheless, it seems that the new detection methods like measuring of transverse electron tunneling using nanogap electrodes or optical detection can offer significant additional advantages. The aim of this review is not to cite all related articles, but highlight the steps, which in our opinion, meant important progresses in solid‐state nanopore analysis.